Grabs Position Error
First things you need to checkEnsure the grab arms are perfectly straight and are not
dropping down on an angle or up on an angle. (They must be parallel to the grabber arm chassis) The brass rollers on the grabber arms must be clean and moving well. The platen table matt in good condition The optical sensors are clean |
CauseOrigin Sensor (B10a) detects nothing
|
If the error still comes up then check these
- C13a sensor failure (always staying OFF)
- Gear failure of the Turret
- Turret Motor failure
- -urret Motor connectors failure
- No clearance between Turret Motor Gear and Turret